283
It is suitable for:
• LVT flooring
• Heavy wear use areas in domestic
and commercial locations
• When castor chairs are used (EN 12 529)
Suitable on:
• Level, absorbent, sound surfaces
• Underfloor heating systems
Epoxy Resin
Epoxy resin is a two-part mix. Both
components should be mixed together
with a drill and paddle to a smooth
consistency and the contents poured out
within 5 minutes of mixing time. If left
within the container the resin will harden
inside 15 minutes; on the floor you have
up to 1 hour working time.
Recommended for areas subject to excessive
moisture and temperature. Any areas under
question consult your supplier.
NOTE: Installer must wear eye protection
and gloves when using this product.
High Temperature Adhesive (HT)
A modified Acrylic adhesive with an
improved service temperature. For use in
areas subject to excessive heat and direct
sunlight e.g. conservatories, shop windows,
patio doors, external glass paneled doors
and under floor heating. Dry fit floor in
sections. Remove dry flooring including
cuts. Apply High Temperature adhesive
with an A2 trowel in smooth consistent
sweeps. DO NOT leave puddles or streaks.
Place flooring into wet adhesive. Apply
hand roller over newly bonded floor. Wipe
any excess adhesive of flooring
immediately with clean damp cloth.
We always recommend that you work
section by section, as product must be laid
in wet adhesive. When using this adhesive
the open time is approximately 15 minutes,
depending on atmospheric conditions.
Special note about conservatories:
In areas that maybe subject to extremely
excessive direct heat 50°C or above
(e.g. fully glazed south facing
conservatories) the floor must be installed
with epoxy adhesive.
It is particularly necessary to keep the
temperature in conservatories at a
constant 18°-26° prior to, during, and for
24 hours after installation. It would also be
advisable to shade windows to ensure that
constant temperature conditions are
maintained for 48 hours after installation.
Acrylic
Ideal for use in most normal residential
and commercial installations. We always
recommend that you work section by
section, as product must be wet bonded
when installed with this adhesive (the
open time is approximately 15 minutes,
depending on atmospheric conditions)
Pressure Sensitive Adhesive (PS)
Ideal for use in most normal residential
and commercial installations.
Best used as a semi-dry/tack. Once
adhesive has reached the semi-dry tack
condition you will have approximately
2 hours working time. Use A2 trowel for
all installations.
IMPORTANT:
We must insist that all Karndean
Designflooring products are laid using
a suitable adhesive. An A2 trowel should
always be used to apply Karndean
Designflooring adhesives.