194
15. Finish of with a spatula over the entire
floor
NB. To forestall potential problems with
the deviation of wheeled traic when
crossing the dense pile of Flotex, we
strongly recommend that the
floorcovering be laid lengthways along
the main traic paths. Artline can be used
to disguise changes at junctions and as a
design feature in corridors over 2 metres
wide.
Karndean Designflooring will not accept
complaints once the fourth sheet has
been laid.
Laying Flotex on a staircase
Flotex roll is suitable for use on stairs,
following these guidelines:
1. Nosing should always be used
2. A separate piece of Flotex must be
used for each tread and riser
3. Use contact adhesive only
Artline Borders
Edging a room with
Artline Borders
This method may be followed when
Flotex Artline is being used to border the
edge of a room:
1. Lay the Flotex sheets, leaving room for
the Artline borders. Allow 1cm - 2cm
trim from the Artline in case the walls
are not perfectly straight
2. Lay the borders.
3. Press firmly home with a spatula
4. Trim and press home again
Inlaying and Borders
1. Lay and adhere all the sheets in
the room
2. Measure out the locations for the
Artline strips
3. Mark with white chalk
4. Place the cutting guide in position
5. Cut piece out from both sides
6. Remove the cut piece of floorcovering
7. Apply a new layer of Mega-Bond
adhesive
8. Lay the Flotex Artline border in position
9. Using a spatula, press border firmly
into place